Products
4-SIDE MOULDER
Standard Model：SKG-400
Features:-
In addition to integrating all features on the SKG series, the function of SKG-300 / 350 is greatly upgraded. The increased width of cutting capacity allows the SKG-300 / 350 to cut wider panel. Furthermore, the special equipment is provided on each horizontal spindle for achieving the best finish on the surface after cut
Vertical Out broad Bearing Device
The device provides extra support for vertical spindle to get better cutting performance and perfect finish quality.
Movable top pressure Roller
After special design the top pressure wheel can be movable, users change the cutter easier and more convenience.
Double Side Air Loaded Feed Rollers(Incl. External Bearing Support) (Roller Diameter 200 mm)
Suitable for working width over 400mm, these feed rollers provide stable feeding and more uniform feeding with double side pressure. They are ideal for both planning and sawing operations.
Pneumatic Pressure Side Wheel at Infeed Table
Eliminate the use of conventional spring load, the side pressure wheel is loaded by air system. This feature not only provides higher pressure, but also allows for flexible adjustment of pressure. No elastic fatigue occurs. The air loaded side pressure makes the machine ideal for high speed cutting operations.
Upper horizontal Out Broad Bearing Device
The device provides extra support for horizontal spindle to get better cutting performance and perfect finish quality.
Bottom horizontal Out Broad Bearing Device
The device provides extra support for horizontal spindle to get better cutting performance and perfect finish quality.
Spindle
The spindle is supported by two pair of bearing to ensure accurate performance under high speed rotation.
Pneumatic Pressure Device at Opposite Side for Right Spindle
Pneumatic Pressure Device for Top Spindle
Parameters:-
MODEL
SKG-400
Working width min.~max.
20~400 mm
Working height min.~max
10~200 mm (Opt. 250mm)
Infeed table length
1.2 M
Motor horse power
20 HP & 25 HP
Feeding power
10 HP (Opt. 15HP)
Feeding speed
6 ~36 M/min
Diameter of spindle
50 mm
Spindle speed
6,000 RPM
Tool diameter of first bottom spindle
125~180 mm
Tool diameter of vertical spindle
125~180 mm
Tool diameter of horizontal spindle
125~230 mm
Adjustment range of straightening table and edge-joint
10 mm
Adjustment of vertical spindle
50 mm
Adjustment of horizontal spindle
30 mm
Diameter of feeding roller
200 mm x ø35 mm
Width of steel feed roller
25 mm
Width of steel feed rollers opposite left spindle
20 mm
Width of rubber feed roller
50 mm
Max. cutting capacity for 1st bottom spindle
10 mm
Max. cutting capacity for 2st right vertical spindle
10 mm
Copyright © 2024 - 2026 - avimpex.co.in Made with ❤️ by PrimeWebX.com